|
Meet code with
Trace's new DC disconnect/over current module, TRACE DC DISCONNECTS
DC250 and DC175 DC disconnects and Options Xantrex-Trace
DC250 250 amp breaker with enclosure. For SW4024,
SW5548, PS2212, PS2512, DR3624 and DR2412
(Use #4/0 AWG cable min.)
DC175 175 amp breaker with enclosure. For SW4048,
PS2524, DR1512, DR1524 and DR2424
(Use #2/0 AWG cable min.)
GJ250 Additional 250 amp breaker (field
installable) for a second, stacked or unstacked SW or DR inverter
GJ175 Additional 175 amp breaker (field
installable) for a second, stacked or unstacked SW or DR inverter
DCBB Negative/ground bonding block - connects up to
two #4/0 AWG negative cables and various
ground system cables
CD60DC 60 amp circuit breaker for solar array input
disconnect for a C40 (mounts on side of DC250/175)
CD15 15 amp circuit breaker for small DC load -
mounts on side knockout of DC disconnect enclosure
CD20 20 amp circuit breaker for small DC load -
mounts on side knockout of DC disconnect enclosure
code with Trace's new DC disconnect/overcurrent module
Now it's
easier to meet National Electric Code requirements with a Trace DC175 or
250. These modules are designed to link with Trace SW and DR series
inverter systems.
Battery
disconnect:
An easy way to isolate inverter and battery
- Meets
National Electrical Code requirement for "means of disconnection."
- No exposed
"hot" terminals
- Doesn't
need ring terminal lugs
-
Overcurrent protection: DC circuit breakers UL listed for up to 125VDC
- Extremely
low voltage drop (less than most fuses or current shunts)
- Rated for
interrupting high fault current (up to 25,00 amps at 65 VDC)
- Easy to
reset
- No exposed
"hot" terminals
Room for
expansion
- Optional
second main breaker accommodates dual inverter systems
- Second
breaker can be field installed
- Space
allows for DC current shunts
Optional
bonding block simplifies wiring and grounding
- Bonds
negative conductor to grounding system at single point
- Lugs to
terminate four 4/0, two #1/0, two #2 and four #4 cables
Four
Auxiliary breaker positions
- Optional
15-amp DC breaker for small DC loads or equipment room light
- Optional
60-amp DC-rated breaker for PV array disconnect, charge controller, etc.
- UL listed
for DC systems up to 125 VDC
- Rated for
interrupting high fault current, up to 25,000 amps at 65 VDC
- Easily
accessible #10-32 stud terminals
Note:
Products are listed by UL and/or ETL to UL specifications
|
