• Enclosure is most often installed on the light pole near the base of the pole.
• Advantage of installing the aluminum enclosure on the light pole near the base of the pole is that it reduces the amount of weight on the pole.
• Installing the enclosure near the top of the pole may reduce the risk of vandalism but limits your access to the batteries and to the electronics.
• The weight of the enclosure plus the weight of the batteries at the top of the pole increases vibration at the base of the pole caused by wind;
• We do not recommend installing the enclosure near the top of the pole. Enclosure should be installed on the pole within three (1-4) feet from the base of the pole.

• For regions in which there is considerably low temperature, please surround the batteries with foam panels, as in the attached sample.

Note: for systems that weight less than 120Lbs we ship only the top Mounting brackets.

if you need more please contact our sales department.

Matching white power coat finish aluminum channels are used for
wall or pole mounting. Slotted pattern allows U-bolt sizes from 2”
to 8” (schedule 40 pipe) or larger band clamps. Brackets are first
mounted in place on wall or pole. Enclosure is then hung in place
on top bracket and bolted through lower bracket to secure ‘carriage-bolts’ for vandal resistance.

All OK series enclosures include interior studs for mounting of ‘Rear’ and ‘Right-Side’ back panels and
an interior door panel.

Back panels are made of 0.080” brushed aluminum with four mounting holes.

Right-side and door panels are blank, rear panels are either blank or with 39 pre-located holes for #8
self tapping screws, allowing simple attachment of most commonly used PV controllers, breakers, terminal strips, surge arrestors, and ballasts.

Top Opening Enclosure Mounting Panels
Blank panels are 0.125” brushed aluminum with four mounting holes for side and top cover
locations to allow attachment of OEM controllers and other components. Side panel fits all chest sizes. Top panel fits both 6 x 4D & 6 x 8D enclosures.