|
Meet code with
Trace's new DC disconnect/over current module, TRACE DC DISCONNECTS
DC250 and DC175 DC disconnects
and Options Xantrex-Trace
DC250 250 amp breaker with enclosure. For SW4024,
SW5548, PS2212, PS2512, DR3624 and DR2412
(Use #4/0 AWG cable min.)
DC175 175 amp breaker with enclosure. For SW4048,
PS2524, DR1512, DR1524 and DR2424
(Use #2/0 AWG cable min.)
GJ250 Additional 250 amp breaker (field
installable) for a second, stacked or unstacked SW or DR inverter
GJ175 Additional 175 amp breaker (field
installable) for a second, stacked or unstacked SW or DR inverter
DCBB Negative/ground bonding block - connects up to
two #4/0 AWG negative cables and various
ground system cables
CD60DC 60 amp circuit breaker for solar array input
disconnect for a C40 (mounts on side of DC250/175)
CD15 15 amp circuit breaker for small DC load -
mounts on side knockout of DC disconnect enclosure
CD20 20 amp circuit breaker for small DC load -
mounts on side knockout of DC disconnect enclosure
code with Trace's new DC
disconnect/overcurrent module
Now it's easier to meet National
Electric Code requirements with a Trace DC175 or 250. These modules are
designed to link with Trace SW and DR series inverter systems.
Battery disconnect:
An easy way to isolate inverter and battery
- Meets National Electrical Code
requirement for "means of disconnection."
- No exposed "hot"
terminals
- Doesn't need ring terminal lugs
- Overcurrent protection: DC
circuit breakers UL listed for up to 125VDC
- Extremely low voltage drop
(less than most fuses or current shunts)
- Rated for interrupting high
fault current (up to 25,00 amps at 65 VDC)
- Easy to reset
- No exposed "hot"
terminals
Room for expansion
- Optional second main breaker
accommodates dual inverter systems
- Second breaker can be field
installed
- Space allows for DC current
shunts
Optional bonding block
simplifies wiring and grounding
- Bonds negative conductor to
grounding system at single point
- Lugs to terminate four 4/0, two
#1/0, two #2 and four #4 cables
Four Auxiliary breaker
positions
- Optional 15-amp DC breaker for
small DC loads or equipment room light
- Optional 60-amp DC-rated
breaker for PV array disconnect, charge controller, etc.
- UL listed for DC systems up to
125 VDC
- Rated for interrupting high
fault current, up to 25,000 amps at 65 VDC
- Easily accessible #10-32 stud
terminals
Note: Products are listed by UL
and/or ETL to UL specifications
|
